I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service.
To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel.
The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Esthetics:
Material quality:
Fitting:
Reliable opinion
2020-08-08, 13:12
Rajmund
The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards
Esthetics:
Material quality:
Fitting:
Reliable opinion
2020-11-18, 06:40
Dominik
Hello you have super products with good quality and reasonable prices to buy, I will order products from you more often.
Esthetics:
Material quality:
Fitting:
Reliable opinion
2024-08-25, 12:33
Dawid
Arbor as much as ok, fits everything without any problem is durable does not wear out quickly good quality
Esthetics:
Material quality:
Fitting:
Reliable opinion
2020-01-28, 22:08
Kamil
It fits perfectly on a 2003 Suzuki RM 125. I installed and can continue to ride off-road. Thanks a lot :)
Esthetics:
Material quality:
Fitting:
Reliable opinion
We have Motorcycle brake calipers to Yamaha WR 400