Motorcycle brakes
Kawasaki J 300

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-11-12, 15:59

View original

Krzysztof

Honda Africa Twin XRV 750 1999. The piston fits the calipers on older models, the pistons for my motorcycle are 3mm shorter. I ordered the set with the idea of shortening it. The material turned out to be soft compared to the original(this does not prove its strength, therefore the rating of 3 from the quality), cutting 3mm on the lathe did not overheat the pad and after protecting it on the turning side with an appropriate specific will ensure that it will not lose its anti-corrosion properties. A perfect replacement for the twice more expensive original. The width agrees, the quality of the seals seems to be OK, after installation it does its job - I recommend.

Review translated automatically

Reliable opinion

2021-03-20, 11:29

View original

Bartosz

The motorcycle is a Honda Transalp XL 600 The piston holds the dimension perfectly in every plane. The only difference is the different shape of the bottom of the piston, but this does not seem to affect the operation.

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2020-06-08, 10:06

View original

Łukasz

I am satisfied everything efficiently and according to what I ordered. The ordered goods meet my expectations. I positively evaluate this store.

Review translated automatically

Reliable opinion

2024-05-11, 08:00

View original

Maksym

The shield fits perfectly, does not heat up, you can see that it is made solidly ! I highly recommend this product !

Review translated automatically

Reliable opinion