Motorcycle brakes
Suzuki RF 900 - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2024-08-01, 10:33

View original

Sebastian

Good quality. Each piece of the set packaged separately. Fits perfectly, works, does not leak. Tested and tried and tested. Kawasaki zx7r 1996r Tokico caliper.Thank you.

Review translated automatically

Reliable opinion

2017-05-15, 21:39

View original

Wiesław

Suzuki GSX-R 1100 motorcycle from 1987 . Due to its age I decided to replace the front master cylinder , searching through the offers I came across a repair kit at gmoto.pl and decided to purchase it along with the brake lever that works with the piston and may have been worn out . The parts after unpacking turned out to be not different in appearance and quality from the original with the included box of special grease . With the assembly there was no problem . All parts fit and work as intended .

Review translated automatically

Reliable opinion

2017-11-04, 10:28

View original

Patryk

I own a 2003 Suzuki DL 1000 motorcycle. Reperature of the front brake master cylinder I needed because it began to leak and go hard. The replacement is not difficult and the parts fit well. Even without instructions there are no problems to assemble everything correctly ;)

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2018-05-26, 07:30

View original

Piotr

I installed in suzuki hayabusa, parts fit well, high quality workmanship, the kit contains all the components for a comprehensive repair of the pump

Review translated automatically

Reliable opinion

2022-07-22, 17:30

View original

Piotr

The gaskets fit perfectly, finally dry at the fluid reservoirs, I recommend. As always shopping at Gmoto fast and efficient.

Review translated automatically

Reliable opinion

2023-06-16, 06:50

View original

Marcin

Very good replacement quality materials exceed the original. I bought both the clutch pump and the brake master cylinder. I recommend

Review translated automatically

Reliable opinion

2024-05-11, 08:00

View original

Maksym

The shield fits perfectly, does not heat up, you can see that it is made solidly ! I highly recommend this product !

Review translated automatically

Reliable opinion

2021-05-03, 07:23

View original

Arkadiusz

Suzuki GSXR 1100 year 1995.Kit fits everything ok,fast shipping overseas. I recommend the seller.

Review translated automatically

Reliable opinion