Motorcycle brakes
Yamaha RD 500 YPVS

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2021-11-26, 11:11

View original

Mariusz

Yamaha XTZ 850 4TX workmanship cool,during installation everything went smoothly,disc straight,thickness as original,tested as intended does the job with blue NISSIN pads .

Reliable opinion

2021-02-12, 07:48

View original

Mateusz

New pads for a new disc. Everything fits perfectly under the XJ 600 Diversion '98 (Rear) Put on and ride.

Reliable opinion