Forgot password
Order status
Free delivery from euro
Product ID: 2742974
Highsider CAN-BUS CBW1 Resistor - 207-033
£28.27 including VAT
Highsider CAN-BUS CBW1 Resistor
| Manufacturer: | Highsider |
|---|---|
| Manufacturer id: | 207-033 |
General description
- HIGHSIDER CAN-BUS resistor CBW1 with DIP-switch.
- Our newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles that have a CAN-BUS system.
- The CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit.
- In addition, a reliability is given. This means:If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.
- Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.
- If 2 pairs of indicators need to be changed,also 2 CBW1 needed to be used.
- Which requirements should be met in order to use the CBW1 on the motorbike:
- The motorbike was originally produced with LED indicators or the motorbike has a CAN-BUS System
- If these requirements are not met, the CBW1 unit will not function (!) In this case, we recommend the following resistances:
- For indicators with 21 Watt:6,8 Ohm partnumber 1108546002 or 10 Ohm partnumber 1108546004
- For indicators with 10 Watt:27 Ohm partnumber 1107562
- The following resistance values can be set on the CBW1:
- 150 ohms
- 170 ohms
- 240 ohms
- 300 ohms
- 400 ohms
- 600 ohms
- 1200 ohms
- Dimensions:Height = 11mmWidth = 31mm (without straps)Width = 46mm (with tabs)Length = 40mm
- Cable length = 200mm with pins
- Connections:Yellow = input channel 1 (+)Orange = output channel 1 (+)Blue = input channel 2 (+)Red = output channel 2 (+)Gray = input mass (-)Black = output ground (-)
- Hints:– Up to 2 channels can be operated.– The connection is explained precisely in the mounting instructions!
