Motorcycle brakes
Honda CBX 750

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2024-09-20, 06:29

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2024-09-20, 09:22

View original

Ralph

Beautiful orange colored hose clamp, unfortunately the rubber in the inner part is very large to the clamp so that you see little of her.better use a smaller rubber then she looks very good

Review translated automatically

Reliable opinion

2025-01-24, 10:59

View original

arcas

Very good product for replacing original discs. No premature wear, so good durability, a good product for a non-sporty scooter.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion

2021-04-09, 17:18

View original

Piotr

Recommended. 100% satisfaction. Full compatibility. Fast delivery, seamless transaction. Thank you and best regards.

Review translated automatically

Reliable opinion

2025-06-05, 04:31

View original

Pekka

Otherwise good, but 5mm longer than the original 1984 Honda CB400N pin. However, it didn't interfere with the installation.

Review translated automatically

Reliable opinion

2022-01-23, 22:26

View original

Michał

The piston fits the caliper perfectly. It is dimensional, consistent with the original. Used in older nissin calipers.

Review translated automatically

Reliable opinion

2024-05-12, 04:57

View original

Piotr

Everything fits. The pads brake very well recommend. Product quality very good at a good price.

Review translated automatically

Reliable opinion

2022-05-29, 20:10

View original

Jacek

Honda Varadero 125, parts fit, everything works as expected after installation, quality of goods good.

Review translated automatically

Reliable opinion

2025-09-23, 07:56

View original

Omar

perfect 1st order on this site to put in your favorites I recommend .

Review translated automatically

Reliable opinion