Motorcycle brakes
BMW HP4 1000 ABS 2012

• 
• 
• 

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

• 

Aprilia rsv 4 factory 2014 User only on tracks. It eats brake pads very much. I already had these pads on my previous motorcycle ktm RC 8R and so in Brno on the track I could afford very loose brakes.I rode a lot of tracks on them. They do not wear off easily and do not damage the disc. I highly recommend.