Motorcycle brakes
Honda CA 125 Rebel 1998

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2017-04-04, 17:58

View original

Michał

Honda Shadow VT 125C - At first I was slightly concerned because after a quick fitting these shoes were slightly different from the predecessors, but after replacement, however, it turned out that they fit perfectly, the contact surface of the shoes to the brake drum is probably even better than in the predecessors. as for the performance on the road itself, I have not yet thoroughly checked, but from the preliminary "tests" braking is definitely better.

Reliable opinion

2022-05-02, 11:27

View original

Mirosław

Honda SW T400 year 2010 automatic stop lights workmanship good, fits very well without any problem I installed. It met my expectations.

Reliable opinion