Motorcycle brakes
Honda CBR 600 F - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2024-08-25, 12:33

View original

Dawid

Arbor as much as ok, fits everything without any problem is durable does not wear out quickly good quality

Review translated automatically

Reliable opinion

2020-01-28, 22:08

View original

Kamil

It fits perfectly on a 2003 Suzuki RM 125. I installed and can continue to ride off-road. Thanks a lot :)

Review translated automatically

Reliable opinion

2021-03-13, 08:30

View original

Krzysztof

Suzuki DL 1000 02r. Very good quality at an affordable price. Excellent fit. I recommend 100%.

Review translated automatically

Reliable opinion