Motorcycle brakes
Honda CBR 650 FA ABS 2014

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2022-08-02, 22:30

View original

Andrzej

I own a 2013 Honda Cb 500 F motorcycle. Pads very good quality, well packaged and I have already ridden are sharp and after reaching are braking well compared to the previous ones are sharper.

Review translated automatically

Reliable opinion

2020-03-06, 07:17

View original

Mariusz

TRW pads are a brand in itself. There is nothing to complain about, they fit and work perfectly. Worthy of recommendation for all users.

Review translated automatically

Reliable opinion