Motorcycle brakes
Honda XL 650 Transalp - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2024-05-02, 17:02

View original

xxx

I am really satisfied with the purchased bolt. It is well made and meets my expectations, it is a good choice, I will definitely order something again and more than once.

Reliable opinion

2025-01-11, 22:40

View original

leon

Zadovoljan proizvodom,narucio sam jos neke stvari.Jedina zamjerka sto nema opcija placanja poduzecem i dugo se ceka da se dostavi (ja konkretno 18 dana)

Reliable opinion

2024-08-25, 12:26

View original

Dawid

Pads are ok for a long time, brakes very well, price to quality ratio very positive

Reliable opinion

2024-11-07, 08:28

View original

Furui

Geliefert wie bestellt. Alles in Ordnung. Ich würde wieder bei GMoto bestellen. Es ist ein verlässlicher Lieferant.

Reliable opinion

2024-11-20, 01:29

View original

Robert

Zakupione na przód i tył, jak na razie bez problemów. Zakladalem je także do innych motocykli enduro oraz sportów

Reliable opinion