Motorcycle brakes
Kawasaki ZRX 1100 - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2021-03-08, 14:57

View original

Dawid

Kawasaki Z 750 S 2005. The bolts serve their purpose. They fit well, and although at the final tightening they began to slightly work (which is surprising given that they are TRW), they enabled the disc to be tightened to the correct torque. Overall I recommend.

Reliable opinion

2024-05-12, 04:14

View original

Norbert

A very good replacement for the original. In my opinion a little too much thread glue is applied but it will hold better :)

Reliable opinion