Motorcycle brakes
KTM Duke 640 II E 1999 - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2024-05-05, 18:19

View original

Tomasz

The installed repair kit does its job. The pump works properly without the slightest objection.

Reliable opinion

2024-07-07, 20:22

View original

Marcin

The set matched 100% no iade in japan equals no iade in japan equals no i recommend 100% nothing to add nothing to add!!!!!!!!!!

Reliable opinion