Motorcycle brakes
Yamaha YZF-R7 750 OW02 2001

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2020-05-06, 08:38

View original

Hubert

Kit super, the old parts in the motorcycle looked ok to the eye, but however, when I compared with this kit I noticed that the old orings were already shrunken and did not hold the dimensions. Handle now firm and brakes much better :) I recommend

Review translated automatically

Reliable opinion

2022-05-02, 11:27

View original

Mirosław

Honda SW T400 year 2010 automatic stop lights workmanship good, fits very well without any problem I installed. It met my expectations.

Review translated automatically

Reliable opinion

2018-02-17, 19:19

View original

Maciej

Sealers really well made , fit very well . The installation went smoothly and quickly

Review translated automatically

Reliable opinion

2022-03-05, 20:18

View original

Dariusz

The pads fit the motorcycle model well, good quality, braking at a very good level, I recommend.

Review translated automatically

Reliable opinion