Motorcycle clutch
Aprilia MX 50 2003

2024-08-03, 06:21

View original

Jakub

The basket seems to be slightly lighter than the original, whether this is bad or good is not for me to judge, since the replacement I have not had any problems with it. The serrated hole in the middle fits snugly, I had to convince the basket with a rubber hammer to go into place, on the other hand there is no play (xD). Since this procedure it goes in and out smoothly, so it's not that it's impossible to remove it later (although it's possible that it's the fault of some mess in my clutch). The piece is carefully made, with no cavities or damage. I recommend

Review translated automatically

Reliable opinion

2020-06-04, 00:52

View original

Adam

Yamaha TZR 50 2007. Seal seemingly superfluous when installing the cover, but with this engine to accurately adjust the clutch we have to pull off the cover. Here the gasket is reusable and this makes our work easier. The fit is exemplary - I mount it with grease and it is always dry. I recommend.

Review translated automatically

Reliable opinion

2021-06-09, 12:58

View original

Bartek

The pads fit Yamaha DT 80 LC 2 53V, The clutch works properly on them. The set came naturally the right amount, nothing to worry about :)

Review translated automatically

Reliable opinion

2020-06-06, 09:29

View original

Maciej

In the description it says that it fits 2008 yamaha xt 125 but unfortunately it is not so they are too big for this model.

Review translated automatically

Reliable opinion