New 6V LED turn signal flasher
| Manufacturer: | Kengo |
|---|---|
| Manufacturer id: | 97124 |
- housing made of plastic
- number of pins: 3
- when installing LED bulbs or turn signals, a regular circuit breaker does not work because they have a resistance many times lower than traditional ones
- the difference in the connection method is the additional wire to ground, because the circuit breaker requires an independent power supply, at the output traditionally +
- height: 42 mm
- base dimensions: 30x30 mm
Connection diagram:
B(49) power cord inlet +
L (49a) power cable outlet +
E ground connection -
Gmoto.pl Paweł Cebulak, Tadeusza Kościuszki 78, 37-100, Łańcut, PL, [email protected]
Product reviews
-
Działa i spełnia swoją funkcję bez zastrzeżeń polecam jeśli ktoś potrzebuje bez porównania do poprzedniego przerywacza
Review translated automatically
Reliable opinion
-
Interrupter works very well .The previous one from another company also designed for led bulbs was going crazy. In my case it was used in WSK 125.
Review translated automatically
Reliable opinion
-
SHL M11 - interrupter inserted for the previous one that had run out, size-wise this one is a little bigger. It gives the impression of being more solid than the one I had before. Installation without any problem due to the fact that the entire turn signal installation was done by me (there were no factory turn signals in SHLs).
Review translated automatically
Reliable opinion
-
Wsk 175 M21w2 Interrupter works flawlessly.The previous one, which I bought complete with led bulbs, on the switched on engine gave a stroboscopic effect .
Review translated automatically
Reliable opinion
-
MZ TS 125 from 1978, the interrupter works perfectly product of high quality. Easy to install and fit to the size of the lamp. Recommended.
Review translated automatically
Reliable opinion
-
WSK 125 1985. I chose an electronic interrupter because the traditional one with a resistance wire used so far sometimes jammed while driving under the influence of vibrations - the indicators lit up with a continuous light. Now the problem has disappeared. Only its interruption frequency is a tad too high, but this is probably because it is designed for LEDs and I have ordinary two bulbs of 21watts per side. I recommend
Review translated automatically
Reliable opinion
-
hop 175
Review translated automatically
Reliable opinion
Questions & Answers
Have a question about this product?
No one has asked a question about this product yet. Be the first and get an answer from our community or experts!