Forgot password
Order status
Free delivery from euro
Manufacturer
Price
Sort
£1.67
Lowest price from 30 days before discount: £1.76
delivery 0 £Engine seal 14x22x5 - M730900435010
Options +4 £85.47
Lowest price from 30 days before discount: £94.97
delivery 0 £DID 520 ZVMX 112 X-Ring open drive chain with lugs
(6) 
Options +4 £94.12
Lowest price from 30 days before discount: £104.58
delivery 0 £DID 520 ZVMX 112 X-Ring G&G open drive chain with gold cap.
(6) 
Options +16 £25.21
Lowest price from 30 days before discount: £28.01
delivery 0 £DID 520 112 open drive chain with fastener
(27) 
Options +17 £41.70
Lowest price from 30 days before discount: £46.33
delivery 0 £DID 520 NZ 112 open drive chain with fastener
(1) 
£15.96
Lowest price from 30 days before discount: £16.80
delivery 0 £EBC 318 brake shoes - H318G
(1) 
£10.65
Lowest price from 30 days before discount: £11.21
delivery 0 £NGK CR8EHIX9 iridium spark plug - R8EHIX9
(6) 
from 5
Browse by manufacturer
Products reviews
I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Review translated automatically
Reliable opinion
Honda Africa XRV 750 - 1999. I bought 12 pieces. This mounting rubber is found in several places on the motorcycle(the mount of the skull rack, oil cooler, plastic handles, etc.). It looks like the original, the rubber is flexible, you can bend it with two fingers with a stronger squeeze and it looks solid. Only the course of time can verify whether it is as solid. Dimensions: Hole diameter(nominal): 10mm Width of the entire rubber: 22mm Groove depth: 8mm
Review translated automatically
Reliable opinion
2000 Honda CBR 600F. The regulator works as expected + good price. I had previously tested a custom-made regulator, purchased at reg_mot.republika.pl, and unfortunately found that it drew current at a standstill, and was quite a bit larger than the standard regulator and required rearranging the components under the fairing. Tour-max regulator is the same size as the original, works perfectly. I am satisfied, I recommend it!
Review translated automatically
Reliable opinion
Honda Cb500 PC26 - 1994 Includes the parts needed to repair the front brake master cylinder. These are not the original Honda parts, but they are good quality and fit the brake pump perfectly.
Review translated automatically
Reliable opinion
Purchased to completely rebuild my Nissin 11mm master cylinder. The kit fits perfectly. My master cylinder is back for life.
Review translated automatically
Reliable opinion
Honda Shadow 125 ,year 2000 chain fits perfectly. Everything in order,I highly recommend Gmoto.pl
Review translated automatically
Reliable opinion
Honda Shadow VT 125C - At first I was slightly concerned because after a quick fitting these shoes were slightly different from the predecessors, but after replacement, however, it turned out that they fit perfectly, the contact surface of the shoes to the brake drum is probably even better than in the predecessors. as for the performance on the road itself, I have not yet thoroughly checked, but from the preliminary "tests" braking is definitely better.
Review translated automatically
Reliable opinion
DID chains, as you know, have an excellent reputation among motorcyclists. Not without reason. Excellent quality and durability. This model perfectly supports motorcycles with power reaching well over 100 hp. Its durability is perfectly evidenced by the fact that I had to get a new, better cupping machine to install it. The current one gave up. The chain is extremely durable. I recommend it to everyone!
Review translated automatically
Reliable opinion
Installation: perfect fit to the frame holes (Honda CBR 600F4) Operation: charging at idle 13.4-13.7 V, maximum charging voltage 14.4-14.6 V (holds until cut-off, measured with a meter) The price is quite exorbitant, although the parameters reflect what it should be. Cheaper Chinese ones I'm afraid of, while here there is more confidence in the quality of the product.
Review translated automatically
Reliable opinion
Honda NTV 650 Revere 97r. Kit well made, good quality parts, easy installation good fit. Replaces the original parts well, the pump works flawlessly. I would like to add that the kit was purchased on the recommendation of a Honda service employee because the original repair kit costs almost 4 times as much, and this one does its job 100%. I sincerely recommend.
Review translated automatically
Reliable opinion
Bmw R 1100 RT 2000 year, I purchased a set of consumables. Very friendly, professional service and advice. Competitive prices. They respond to emails. You are kept informed about the shipping status. This was my 3rd contact with the company. I recommend, I will certainly use again more than once. Regards, Tycjan
Review translated automatically
Reliable opinion
The sensor looks like I got a damaged or defective one from the factory. After screwing the nut in, the thread simply broke. I had to screw in the old sensor. I am waiting for a solution to the issue. The rest of the products ok.
Review translated automatically
Reliable opinion
Honda shadow 125. chain is ideal, quick installation, noticeable improvement in motorcycle performance, bdb price lowest on the market. It is a good alternative to expensive oring chains. Recommended.
Review translated automatically
Reliable opinion
This mounting rubber is a great replacement for the rubbers found on the Honda CBR 600, but they are slightly smaller than the original (I personally didn't mind the installation)
Review translated automatically
Reliable opinion
Yamaha XT600 E 3TB 1991 | Sensor well made. On XT/TT 600 models For proper operation, this sensor should be mounted on silicone without a copper gasket.
Review translated automatically
Reliable opinion
Fits new tubes without a hitch, and after several km on normal roads, no leaks to report. We'll have to wait and see how the rubber ages over time.
Review translated automatically
Reliable opinion
The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards
Review translated automatically
Reliable opinion
Valve the same as the original which had probably enough. Fitted perfectly and works perfectly on the motorcycle, overall the store has bdb parts so I will be back!
Review translated automatically
Reliable opinion
Honda VTX 1300 2006. The master cylinder was reconditioned with the kit purchased. Fast, efficient. High quality goods. The pump works like new.
Review translated automatically
Reliable opinion
Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.
Review translated automatically
Reliable opinion
Sealers fit varadero 125 2002, workmanship ok, trouble-free installation. So far the suspension works ok, we'll see how long they last.
Review translated automatically
Reliable opinion
Goods very well packaged and protected in a clear box, you can see what you are buying made solidly and with good materials. Recommended.
Review translated automatically
Reliable opinion
Honda transalp 600v,1995. Universal kit , well fitted , works flawlessly. Quality of materials at a high level. I recommend .
Review translated automatically
Reliable opinion
The kit fits KMX 125 without any problems. 74zł is the cheapest option I found. I recommend. The motorcycle again goes where I want it to go.
Review translated automatically
Reliable opinion
Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.
Review translated automatically
Reliable opinion
BMW R1150 RT 2002 YEAR, the replacement went quickly and without any difficulties, gaskets very good according to my expectations
Review translated automatically
Reliable opinion
Bought for 1982 Honda CB 750 Custom. Occasionally some of the carburetor leaks, but so far it's holding up well. We'll see how long it lasts ?
Review translated automatically
Reliable opinion
Spark plugs I purchased for my Honda VTR 250 motorcycle after installation the motorcycle fired up beautifully the engine work more evenly I recommend it
Review translated automatically
Reliable opinion
Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.
Review translated automatically
Reliable opinion
100% compatible with the original, on a plug and play basis, identical dimensions, plug socket. Works flawlessly.
Review translated automatically
Reliable opinion
Good product - the aphrodite stopped "buzzing" at higher speeds. I also have the impression that it got a bigger kick ;)
Review translated automatically
Reliable opinion
Perfect. The item is identical to the original. The delivery time is satisfactory. I recommend this site.
Review translated automatically
Reliable opinion
There is nothing much to describe here the candle works great fits daelim daystar 125 I am fully satisfied
Review translated automatically
Reliable opinion
This repair kit is great! Very easy to install! In 30 minutes my master cylinder was repaired
Review translated automatically
Reliable opinion
Quality product.I am extremely pleased with its durability.I recommend it to everyone who might need it.
Review translated automatically
Reliable opinion
Honda Transalp XL 600 1999. Rubber installed fits it is not orginal but can be goes in its place .
Review translated automatically
Reliable opinion
Sealers are made of a good rubber material by which it seals well the lagi nothing leaks. I recommend.
Review translated automatically
Reliable opinion
Excellent product , thank you . Please note that the GLS company planned to deliver on the 13th but the parcel was delivered on the 16th.
Review translated automatically
Reliable opinion
Honda Shadow 125 2000r, candles as described, shipping very efficient, successful shopping, recommend this store
Review translated automatically
Reliable opinion
I am satisfied with my purchase I bought the product for my Honda CBR F3 everything fits and works I recommend.
Review translated automatically
Reliable opinion
Other models of
- Honda VT 125 C Shadow 2007
- Honda VT 125 C Shadow 2008
- Honda VT 125 C Shadow 2003
- Honda VT 125 C Shadow 2003
- Honda VT 125 C Shadow 2002
- Honda VT 125 C Shadow 2005
- Honda VT 125 C Shadow 2005
- Honda VT 125 C Shadow 2007
- Honda VT 125 C Shadow 2008
- Honda VT 125 C2 Shadow 2002
- Honda VT 125 C2 Shadow 2002
- Honda VT 125 C Shadow 1999
- Honda VT 125 C Shadow 1999
- Honda VT 125 C Shadow 2000
- Honda VT 125 C Shadow 2000
- Honda VT 125 C Shadow 2001
- Honda VT 125 C Shadow 2001
- Honda VT 125 C Shadow 2004
- Honda VT 125 C Shadow 2004
- Honda VT 125 C Shadow 2006
- Honda VT 125 C2 Shadow 2000
- Honda VT 125 C2 Shadow 2000
- Honda VT 125 C2 Shadow 2001
- Honda VT 125 C2 Shadow 2001
- Honda VT 125 C2 Shadow 1999
- Honda VT 125 C Shadow 2009