Motorcycle parts
MZ ETZ 125 hamulec tarczowy 1985

2018-11-02, 09:29

View original

Aleksander

WSK 125 75r | The frame fits in the org. holes in the rear lamp mount. I recommend, because this product is worth its price and it is practically indispensable in the mounting of the plate.

Review translated automatically

Reliable opinion

2020-04-28, 09:34

View original

Piotr

In this price range, there is nothing to complain about. The product will do its job. It should certainly survive more than one motorcycle trip.

Review translated automatically

Reliable opinion

2025-08-24, 19:11

View original

Мариан

Price quality perfect just made for home little repairs I personally liked very much how NITI

Review translated automatically

Reliable opinion

2022-07-06, 08:20

View original

Filip

Motorcycle: Yamaha xt 125, year 2005. chain perfectly suited to the motorcycle for the gear ratio 13/50. Impressive because of the gold-plated parts, effective because of the absence of corrosion marks, which translates into good work and preservation of equipment. The fastener mounting method is great, no additional tools are needed other than a flathead screwdriver. In general, I strongly recommend it.

Review translated automatically

Reliable opinion

2017-04-14, 11:33

View original

Michał

Hello. I own an ETZ 250 motorcycle - for it I also purchased the product shown above (4 pieces). Each of the bulbs shines well; they were not broken, did not require complaints. They fit 'tightly' into the BA7S holders - and that's good. There is then no risk of them slipping out while driving. Aesthetics leave nothing to be desired - a bulb like any other. I recommend this product.

Review translated automatically

Reliable opinion

2022-03-09, 09:06

View original

Adrian

Unfortunately, the frame is made very poorly, due to carelessly cast material at the edge, the license plate does not fit and it is impossible to close the latches. It is better to spend a few zlotys more for a better quality product that will have the correct dimensions. Despite the not too bad aesthetics, I advise against the product, it does not serve its purpose.

Review translated automatically

Reliable opinion

2020-05-03, 00:23

View original

Maciej

Wsk 125 The frame is nice, you can't expect more from a plastic metallized one. It fits my wsk-i nicely. The only big minus is that it did not fit completely in the holes - I had to widen the holes with a drill both at the top and bottom. Other than that, installation was easy. I recommend the product for those who don't mind making up holes.

Review translated automatically

Reliable opinion

2024-09-24, 15:15

View original

Marek

I bought with my soul on my shoulder, but the chain shackled elegantly and without any problems. Rather, it is not a typical workshop tool, but 2-3 more chains will surely forge - the pin shows only light wear so it is made of fairly decent materials (considering the price, of very good).

Review translated automatically

Reliable opinion

2021-05-08, 07:38

View original

Andrzej

Plastic license plate frame looks like a good chrome material I changed the plate because I became the owner of a Suzuki Intruder VL 125 2000 year all in all. Looks super material fine that's why the price very low ugly comes longer.

Review translated automatically

Reliable opinion

2018-02-19, 10:51

View original

Piotr

Hello I have a lot of motorcycles in my garage, currently I am dealing with Jawa 350Ts, the installation went without a problem Jawa runs without any complaints .The next motorcycle in my plan to restore will be a 1976 Kmar Sport and I will certainly buy some parts in your store greetings

Review translated automatically

Reliable opinion

2018-02-09, 19:35

View original

Andrzej

MZ ETZ 125 90" switch looks like cheap crap and overall it works that way too.Material quality poor. In neutral it is skewed to one side but it works. There was a problem unscrewing the plastic to install it in the housing because the screw turned.

Review translated automatically

Reliable opinion

2023-07-15, 05:33

View original

Kamil

Frame very cool massive with a cool composing company logo unfortunately I did not use the purchased item because my board is smaller than I anticipated ? but the frame itself I highly recommend as I will measure the size of the board I will order another one like it

Review translated automatically

Reliable opinion

2024-01-11, 07:04

View original

Jacek

The element is made of good quality plastic, allows for repeated mounting and dismounting. The number and size of the mounting holes allows you to conveniently adjust the mounting of the element. Shape and aesthetics of workmanship at a really good level

Review translated automatically

Reliable opinion

2022-01-24, 07:32

View original

Bogusław

License plate frame very solidly and aesthetically made, the size of the plate perfectly matches the size of the license plate, the mounting holes of the frame even fit into any bracket that are found at the motorcycle.

Review translated automatically

Reliable opinion

2019-06-17, 07:58

View original

Damian

In the category of quality/price very nice frame. Strong plastic imitating chrome. Aesthetics at a high level. Lightweight and durable And the license plate enters on contact ( for me a plus because there is no slack). I recommend

Review translated automatically

Reliable opinion

2020-08-05, 23:16

View original

Michał

The caliper does its job as much as possible. The only drawback is its size - it is smaller than the original caliper and has a slightly different design, which does not contribute to reducing the braking force.

Review translated automatically

Reliable opinion

2019-05-17, 13:57

View original

Przemysław

Honda St 1300 126 hp 80k hp 2002r , I bought the motorcycle in the commission and there standard commission frame, a little diso-polo with such a ride that's why the frame with the inscription HONDA will perfectly match the new machine ;)

Review translated automatically

Reliable opinion

2016-05-10, 07:37

View original

Dawid

MZ ETZ 150 1990. The chain fits my motorcycle perfectly, both in length and width. Credit is due for including a Polish manual with instructions on how to install the chain.

Review translated automatically

Reliable opinion

2019-07-16, 15:17

View original

Łukasz

Aesthetics and quality leave a lot to be desired. A typical cheap Chinese product. On the other hand, it fits in place of the luminaire well. One can only hope that it will shine for more than a season.

Review translated automatically

Reliable opinion

2017-09-04, 10:25

View original

Mariusz

frame very nice, put on jawa ts 350 looks very good on this motorcycle, installation also very pleasant immediately changes the name of the motorcycle adds better charm

Review translated automatically

Reliable opinion

2021-10-03, 18:05

View original

Kasjan

I own a motorcycle Junak 905 capacity 50ccm the installation went perfectly. The chain itself came very quickly and was very well lubricated and prepared for installation.

Review translated automatically

Reliable opinion

2019-07-20, 08:06

View original

Candlestick_customs

Product on the pattern of the original caliper, fits without any problem on the mounts and brake disc in Mz etz 250 1989. price adequate to the quality. I recommend 100% this product !

Review translated automatically

Reliable opinion

2024-09-25, 05:27

View original

Filip

Very good solution for those who want to replace the license plate frame with a new one. The price is very affordable. The quality of workmanship is also flawless. I can recommend

Review translated automatically

Reliable opinion

2019-03-29, 10:25

View original

Roman

I have 2 old oilers reliable equipment frames fit like a glove I bought 2 pieces well fitted to the dimensions of the board simple to use good material highly recommend

Review translated automatically

Reliable opinion

2024-05-06, 18:33

View original

Jakubek

Clever device,looks quite solid.The first self-cuffing went very easily, from the cupping did 2000km, the chain still in place.

Review translated automatically

Reliable opinion

2023-09-04, 19:41

View original

Witalis

Super lightweight and small, ideal for taking it with you on the go and also for replacing the chain yourself at home. Easy to use and well designed.

Review translated automatically

Reliable opinion

2025-07-20, 06:04

View original

Jaroslav

The goods arrived on time and quickly and work exactly as I expected. Immediately after plugging in it gives the correct voltage. Fit nicely into the space of the old regulator

Review translated automatically

Reliable opinion

2020-04-04, 11:14

View original

Adam

Romet scmb 125, I bought a frame for the reg plate.Appearance , size, quality, price - very good. I recommend! Delivery prompt and well packaged.

Review translated automatically

Reliable opinion

2022-10-29, 08:29

View original

Adrian

Simson S51 1982 year light bulb fits the counter. Well made illuminates the counter and turn signal light without any problem. Installation fast, I recommend.

Review translated automatically

Reliable opinion

2024-03-13, 08:43

View original

Piotr

What to write. A lot of screw cutouts to fit and screw centrally in each vehicle. Also in a Chinese electric. Fits like a glove.

Review translated automatically

Reliable opinion

2021-11-11, 16:39

View original

Paweł

Benelli TNT 125 quick and easy installation for everyone. Shipment ordered for parcel machine shipped quickly. I recommend this product to everyone as well as the store.

Review translated automatically

Reliable opinion

2020-07-19, 10:54

View original

Dominik

Chain for quiet riding(125cc) as much as possible I recommend of course with proper maintenance (I ride regardless of weather conditions)

Review translated automatically

Reliable opinion

2020-04-19, 10:43

View original

Adam

Fuses bought for MZ during electrical repair which admittedly burned all of them, but better fuses than bulbs I recommend buying to spare

Review translated automatically

Reliable opinion

2025-09-18, 10:04

View original

ΔΗΜΗΤΡΗΣ

It has nickel finish but its plastic, the article says metallic but thats wrong, if you want it for enduro bike or adv its not metallic

Review translated automatically

Reliable opinion

2022-01-31, 08:22

View original

Wojciech

This is not the first time I have ordered from Gmoto yet I have not been disappointed shipment always fast on time products also as described I recommend

Review translated automatically

Reliable opinion

2018-05-07, 18:15

View original

Magdalena

WSK M6 B3 1982 Very good quality product easy to install. Fits perfectly, looks very good. Frame worth recommending.

Review translated automatically

Reliable opinion

2018-05-10, 10:22

View original

WOJCIECH

Everything ok I recommend allegrowicz, fast shipping goods as described. Transactions with such sellers are pure pleasure !!!

Review translated automatically

Reliable opinion

2023-08-14, 15:03

View original

Janek

I have not yet assembled and do not know how with the fragility of the plastic, but from the outside it looks positive. On the back a slight unpainting.

Review translated automatically

Reliable opinion

2020-12-28, 09:34

View original

Tomasz

The locking element of the plate falls out, so I screwed it on. Once I had a similar patent and lost the plate, then I did not screw.

Review translated automatically

Reliable opinion

2025-08-25, 07:30

View original

Jari

A usable product. Good pictorial instructions in the package which I followed to attach the chain. I can recommend.

Review translated automatically

Reliable opinion