JMT Honda clutch sensor

Found 4 matching opinions.

ofileanu

Reliable opinion

6 months ago

Foarte multumit a venit exact ce am comandat intr-un timp destul de scurt un pic cam scump transpurtul dar recomand.

Automatic translation View original
ofileanu
Reliable opinion
6 months ago
JMT Honda clutch sensor
Foarte multumit a venit exact ce am comandat intr-un timp destul de scurt un pic cam scump transpurtul dar recomand.
Automatic translation View original

Łukasz

Reliable opinion

2 years ago

Affairs, it conducts electricity. However, it does not fit the 1976 GL1000 K1 model, as it has a larger diameter than the original (factory) and will not go into the hole in the handle holder. I had to take the original one apart despite the damage and was able to repair it. Perhaps this one will fit the specified GL1000 78-79 but I will check this when I gi... more

Automatic translation View original
Łukasz
Reliable opinion
2 years ago
JMT Honda clutch sensor
Affairs, it conducts electricity. However, it does not fit the 1976 GL1000 K1 model, as it has a larger diameter than the original (factory) and will not go into the hole in the handle holder. I had to take the original one apart despite the damage and was able to repair it. Perhaps this one will fit the specified GL1000 78-79 but I will check this when I give it to a colleague. It would be good to have the basic dimensions plotted on the parts in the photo to see if it will fit us.
Automatic translation View original

Johan

Reliable opinion

6 years ago

For my Hondas FT 500 (1983) & XBR 500 (1986) as spares. Remove the lever first, then punch out the old one from the contact pins side; it's an easy, light press fit. When pressing in the new one, align the hook on the switch with the notch in the clutch lever body. Note the hole in the switch also lines up with a hole at the underside of the alu body; it's f... more

Automatic translation View original
Johan
Reliable opinion
6 years ago
JMT Honda clutch sensor
For my Hondas FT 500 (1983) & XBR 500 (1986) as spares. Remove the lever first, then punch out the old one from the contact pins side; it's an easy, light press fit. When pressing in the new one, align the hook on the switch with the notch in the clutch lever body. Note the hole in the switch also lines up with a hole at the underside of the alu body; it's for contact spray when needed. (Better use it before needed; once corroded the inner contact becomes difficult).
Automatic translation View original

Marek

Reliable opinion

9 years ago

Honda cb750k

Automatic translation View original
Marek
Reliable opinion
9 years ago
JMT Honda clutch sensor
Honda cb750k
Automatic translation View original