Motorcycle ignition capacitors

WALDEMAR

Reliable opinion

Cz175 487 year prod.1988, the mount fits, I had to rework the contacts because the predecessor did something, it burns from a kick but does not go into rotation, probably a matter of adjustment.

Krzysztof

Reliable opinion

Greetings. I applied the capacitor to a 1966 SHL 175 motorcycle. It fits, it works, so nothing more is needed for happiness ;) I recommend greetings.

Szymon

Reliable opinion

I purchased a capacitor for a 1980 Jawka M23 with a capacity of 49 cc. After installation in the engine, it works properly. The spark is there, the engine smokes, you can go to the world.

Sebastian

Reliable opinion

Jawa 50 ogar 200 received a new capacitor from gmoto.pl. capacitor very good quality. I would also add that the contact with the store is very good.

AnoniM

Reliable opinion

Romet Ogar 200 A decent condenser for not much money. Works very well so far. I recommend

Bartosz

Reliable opinion

Romet Kadet , the capacitor fits in place of the old one without reservation, the installation went without a problem. Wire minimally shorter than the original about 3mm, but reaches the same with the same arrangement in the spark gap. Remember during installation to soak the felt in oil and properly bend it to adhere to the magnet cam (if you install withou... more

Władysław

Reliable opinion

Romet Ogar 205 from 1990.I received this smaller capacitor with a length of 22 mm , it has a shorter wire and there was a problem with connecting it to the coil.After talking to the store staff I was immediately sent the longer capacitor -27 mm without any additional cost.This capacitor has a wire 5 mm longer and fits perfectly to the above type of Romet. I ... more

Rafał

Reliable opinion

A capacitor is an important component in an electrical system. It is really worth replacing from time to time preventively. Fits into a rometa ogar 205, a little work to put on (pulling off the cover, magneto, etc.), but there were no problems with fitting into the spark gap. After installation, the whole installation works well. Romet Ogar 205, year of manu... more

Kuba

Reliable opinion

Good day I have a WSK 125 and a Cross 125 to WSK platens and capacitor. How much ze 5 minutes I put on without dogging without combining it fit as it should be the same in the cross and the line well fitted and on + with the adjustment you can set yourself on the line than in the carburetor turn in then adjust the carburetor and none of this will happen. Unt... more

Patryk

Reliable opinion

Hi I am Patryk and I own a 1962 WSK 125 m06 z2 , and I buy all parts and accessories from GMOTO. The parts are always matched and good quality.They are well packed and protected in the package. I highly recommend this store just in time to buy parts for our vintage motorcycles.Regards

Marcin

Reliable opinion

WSK M06B3 80 r: The capacitor does its job - but before it did I had to ream one of the mounting holes a bit because they have too much spacing, and I had to bend the sheet metal to the other side because the cable is too short to mount it the way it is originally bent.

Piotr

Reliable opinion

Hello I have a lot of motorcycles in my garage, currently I am dealing with Jawa 350Ts, the installation went without a problem Jawa runs without any complaints .The next motorcycle in my plan to restore will be a 1976 Kmar Sport and I will certainly buy some parts in your store greetings

Krzysztof

Reliable opinion

WSK 125 B1 1970, made as a "vintage" - With battery, but with minor modifications. Capacitor without comments. In platinums required refinement of the hole for the pivot axis and filing of the hole for insulating washers for attaching the wires. 20 min of work with conifers.

Łukasz

Reliable opinion

The parts I ordered (capacitor, platens and ignition coil) actually match the description. After a year's break, my Romet ogar 200 moped finally came to life (it has a spark) and I can enjoy riding it again. Thank you very much!

Łukasz

Reliable opinion

I purchased parts for my WFM 125 M06 from 1954 first models engine . I had concerns about whether I would get parts suitable for this model but the product I purchased fit . Express shipping , I received the parts on the second day . I recommend

Wiktor

Reliable opinion

An indispensable piece of replacement equipment for further trips as well as the home workshop. Part of good quality. Recommended. More about replacement equipment for distant travel at: http://125cmmieszanychuczuc.blogspot.com/.

Jerzy

Reliable opinion

WFM M06, ignition capacitor installed, works fine, a little too short a wire and I had to extend it but as written it is a capacitor for WSK 125 and not for WFM where there is more distance to the interrupter.

Łukasz

Reliable opinion

Romet Ogar 200 engine 223 capacitor fits into the spark plug socket, after installing and adjusting the ignition the bike has a strong spark and turns on the revs well, I strongly recommend this capacitor for Ogar 200

Łukasz

Reliable opinion

Motorcycle I bought 2 capacitors the first was enough for an hour of driving and burned up during the ride on a hot day and push home The second one has been working for quite a long time and is ok so it all depends on the exemplar.

Kacper

Reliable opinion

Super product, when ordering I wrote in the additional information that I wanted a 27mm capacitor and such came. Easy to install because it is exactly like the original. The motorcycle starts, drives properly.